- Finished floor requirement
-
- Fema map number
- 12023C0280D
- Type Roofing Job
- Replacement - Tear off Existing and Replace
- Further Job Details (Explain if decking is being replaced and or Repairs are being done.)
- Remove single layer of shingles /felt to expose decking for examination, re-nail decking to meet current code as needed, Provide/Install new 8" off ridge vents to replace existing, Reuse/reseal existing metal flashing details when possible, Provide/Install new factory painted galvanized eaves drip, Provide/Install OC WeatherLock on areas where pitch is below 4in12, P/I 2 layers of OC ProArmor synthetic underlayment, P/I OC WeatherLock Mat self-adhered leak barriers in valleys, P/I OC Starter Roll at eaves,P/I OC OakRidge Architectural shingles, P/I Oentsure Heat & Moisture Ridge Vent, P/I OC ProEdge hip and ridge cap, P/I new bullet boot pipe flashings and exhaust vent flashings
- Type of structure
- Commercial Building
- Commercial or Residential
- Commercial
- Roof Area (for this job) Sq Ft
- 23059
- No. of Stories
- 1
- Roof Pitch
- 4:12 or Greater
- Is the existing roof being removed?
- Yes
- Type of New Roofing Product
- Asphalt Shingles
- Florida Product Approval Number
- FL10674.1
- Other Roofing Product Type Not Listed
- OC ProArmor Synthetic Underlayment Product Approval code 14299.1
- Product Manufacturer
- Owens Corning
- Product Description
- OC OakRidge Architectural
- Building Code Edition
- 2023 Florida Building Code 8th Edition and 2020 National Electrical Code
- Sealed roof decking options: (Must select an option.)
- two layers of felt underlayment comply ASTM 0226 Type II or ASTM D4869 Type Ill or IV, or two layers of a synthetic underlayment meeting the performance requirements specified, lapped and fastened as specified.
- Ventilation:
- Ridge Vent
- Flashing:
- Use Existing
- Drip Edge:
- Replace All
- Valley Treatment:
- New Metal
- Any cable and/or race-way wiring located on or within the roof assembly?
- No